Flour additive production line

Flour additive production line

Karasanat is the manufacturer of complete lines of all kinds of flour additives, from processing to packaging. The machines used in the line are as follows: 1- The hammer mill is made entirely of stainless steel. How we work. This is the way that the poured powders are guided through the entrance opening into a chamber that has a rotor with stainless steel blades that are smooth on one side and have a relatively sharp edge on the other side. The rotor turns relatively high and \r\ After grinding, the material passes through a grid plate with holes of the desired diameter and discharges inside the barrel. The rotation direction of the rotor (left or right) can be controlled by the operator. The rotor has a speed of 3000 rpm.

2- Ribbon Blender
All parts in contact with materials are made of stainless steel 304, for preparing powder, with a three-part flat lid. The power of the gearbox motor is 10 HP and the shaft speed is 45 rpm. All the parts of the blender are made of stainless steel and all the welds are made with argon tig and the internal and external surfaces are completely polished. The machine is designed with food and pharmaceutical conditions. It is made and all the parts in contact with the material are free of any defects and completely polished.

3- horizontal spiral powder transfer system
to transfer powder from the ground to the filler powder entrance at a height of 2200 mm made of stainless steel,

4- envelope packing machine (ffsa)
We use cellophane and aluminum foil for packing soft and sticky powders. The envelope has three thermal stitches, one in length and two
stitches in width.
Besides, the accuracy of the dimensions of the envelope and the quality of the stitches are much higher. The speed can be changed mechanically and continuously
and the machine is also equipped with an electronic eye to accurately adjust the location of the stitches. In case of order, it is possible to install fully automatic women's date to print three lines on cellophane. The movement of the cellophane is provided by rubber pulleys with the ability to be adjusted very precisely on both sides. The design of the machine is such that in addition to the accuracy of the dimensions of the envelope and the high quality of the stitches, the speed of the machine is higher than similar types.

5- Weighing type filling bag
Weighing type filling bag (load cell) with electromotor brake and processor, for filling bags from 2 to 50 kilos with an accuracy of
negative or positive 0.001 There is an inlet funnel and a sensor on it that can be fed into a continuous spiral by command.
The main screw of the machine discharges the powder from inside the hopper into the bag, which is placed by the operator in a special place and is maintained by a pneumatic bag holding system, and after the weight of the bag reaches the required level, It is stopped through the steering wheel to a brake motor
with spiral movement.

6- Dryer from (12 to 48 trays)
Tray-type powder drying oven with 12 to 48 pieces An aluminum tray capable of drying up to one cubic meter of powder at a time. All surfaces of the furnace are covered with stainless steel sheet from outside and inside. Furnace with two fans, steam coil, valve