Talaq Panasonic 3711 phone dialer----pack of 3 numbers

Talaq Panasonic 3711 phone dialer----pack of 3 numbers

(To buy this product, you can visit our store in Ba Salam and get acquainted with our other products)
https://basalam.com/tusco
The price of each Panasonic telephone dialer is 20,000 Tomans
The dialer is available in a package of four Talaq sheets
This product is produced in several models, depending on the stock, one model is sent to the customer
Of course, almost always the same model that is seen in Tasmir is sent. Of course, there is no difference between them in use
The price of each Talaq sheet for Panasonic phone is 20,000 Tomans
is
The minimum purchase of 3 leaves is 60,000 Tomans
Panasonic wireless phones are one of the best types of phones - the only drawback of these phones is the failure of their buttons after working for a while - in this case, the buttons, especially the disconnect and connect buttons of these phones, are very hard and it is very difficult to work with them.
Unfortunately, cleaning the buttons does not work very well and after some time the problem returns again
The best tool to solve this problem is to use dialer dialer for these phones
Here, we introduce one of the most used talaqs of this phone, which is only used for the following models. According to the pictures, you can easily stick this talaq under the rubber dial and on the phone board using adhesive tape, and not only a few buttons, but all Service the buttons and be at ease for several years
3711 3721 3411 1611 6611 6511 6531 6561 2521
The only important thing is that Talaq is placed on the board in such a way that
First, the colored side should be up and the white side should be on the circuit
Second, the buttons should be placed exactly where the buttons land
Thirdly, the small holes on the talaq should be placed exactly in the place of the small lamps on the board so as not to prevent the lighting of the lights
When opening Panasonic phones, be careful, first loosen the 2 screws inside the battery compartment, then pull the frame from the bottom to the top and be very careful in doing this - at the same time, do not open the frame too much because the phone's ringing wire is short and may be cut off. - The pictures are quite self-explanatory
Before applying Talc, be sure to clean the phone board and its rubber with a little thinner or acetone and with the help of cotton - be careful to use only a little thinner or acetone.
After installing the conductive spacer, put the batteries in the battery compartment and press the buttons with your finger according to the pictures - if the buttons work correctly, close the phone case-
If you still have problems during installation, don't worry, send me a message and I will guide you completely
Panasonic phone models on which this talaq applies are as follows
3711/3721/3411/1611/6611/6511/6531/6561/2521
or any other type whose dialer is like this phone
In addition, the model of these phones is usually written inside the battery compartment, which can be seen by removing the batteries
Good luck